14. Run the BIOS Setup utility to restore the configuration settings to the real-time
clock.
Replacing the SAS expander PCB
To replace the SAS expander PCB, do the following:
CAUTION:
Hot Surfaces: Disconnect power and allow to cool before servicing.
1. Observe all safety and ESD precautions in the Safety and Warranty Guide.
2. Turn off all peripheral devices connected to the storage system. Turn off the
storage system.
3. Disconnect the AC power cord(s).
4. Remove the enclosure cover. For instructions, see “Removing the enclosure
cover” on page 6.
5. Open the PCB cover (see 1 in the following figure). Remove the SAS cable
(see 2). Pull the SAS Expander PCB assembly forward, unplugging it from
the backplane (see 3).
Figure 28. Removing the SAS expander PCB
28 Secure Managed Client (SMC) - Storage Array Hardware Installation and Replacement Guide
Kommentare zu diesen Handbüchern