Lenovo 6431 Bedienungsanleitung PDF herunterladen (Seite 130)

pinched between the hard disk drive fan assembly and the hard disk drive

backplane when the assembly is installed.

c. Rotate the hard disk drive fan assembly toward the backplane until the

release tabs are fully engaged and snaps in place.

11. Reconnect the hard disk drive fan assembly cable to the system board.

12. Rotate the drive cage back into the server until it stops; then, press and hold

the retaining tab on top of the drive cage while you rotate the drive cage into

the chassis until it locks into place.

13. Reinstall the hard disk drives.

Note: Before you continue, check all internal power cables to make sure that

they are connected to the system board and other optional devices.

14. Install the side cover (see “Installing the side cover” on page 63).

15. Lock the side cover.

16. Reconnect the external cables and power cords; then, turn on the attached

devices and turn on the server.

Removing an IBM Remote Supervisor Adapter II SlimLine adapter

To remove a Remote Supervisor Adapter II SlimLine adapter from the server,

complete the following steps:

1. Read the safety information that begins on page vii and “Installation guidelines”

on page 57.

2. Turn off the server and all attached devices; then, disconnect all power cords

and external cables.

3. Unlock and remove the side cover (see “Removing the side cover” on page 62).

4. Rotate the rear adapter-retention bracket out of the server.

5. Press the Remote Supervisor Adapter II SlimLine support-bracket-retention clip

outward slightly and grasp the Remote Supervisor Adapter II SlimLine adapter

and lift it out of the server.

112 ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 283 284

Keine Kommentare

Lenovo 6431 Bedienungsanleitung Seite 130