Lenovo ThinkServer RD540 Bedienungsanleitung PDF herunterladen (Seite 104)

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 86

3. On the Adapter Type Configuration Selection menu, select 1, CNA Configuration.

4. On the Converged Network Adapter (CNA) Protocol Type Selection menu, select 1, CNA iSCSI

Configuration.

5. On the Converged Network Adapter (CNA) iSCSI Configuration menu, select 3, Port IP Settings.

6. Select the Converged Network Port you want to configure.

7. Select 2, Configure IP Settings.

8. Complete the interactive list of settings as follows:

a. Enable IPv4 [on]: Press the ENTER key to accept the default.

b. DHCP to obtain IPv4 Network Information: [off]: Press the ENTER key to accept the

default.

c. IP_Address []: Type the IP address of the initiator system, and then press the ENTER key.

d. IP_Subnet_Mask [255.255.255.0]: Type the appropriate subnet mask, and then press the

ENTER key.

e. IP_Gateway [0.0.0.0]: Press the ENTER key to accept the default.

f. Enable IPv6 [off]: Press the ENTER key to accept the default.

9. On the options menu that opens, select 3, Save changes and reset HBA (if necessary).

10. At the prompt for both ports, type Yes.

11. To return to the Converged Network Adapter (CNA) iSCSI Configuration menu, type p and press the

ENTER key, and then type p and press the ENTER key again.

12. On the Converged Network Adapter (CNA) iSCSI Configuration menu, select 4, Target Configuration.

13. Select the same Converged Network Port you selected in step 6 on page 86.

14. Select 6, Add a Target.

15. Complete the interactive list of settings as follows:

a. IPv6 Target? [off]: Press the ENTER key to accept the default.

b. TGT_iSCSI_Name []: Type the iSCSI qualified name (IQN) of the iSCSI target to connect to, and

then press the ENTER key.

c. TGT_Port [3260]: Press the ENTER key to accept the default.

d. TGT_TargetIPAddress [0.0.0.0]: Type the IP address of the target, and then press the

ENTER key.

16. On the options menu that opens, select 12, Save Target/CHAP Changes.

The iSCSI initiator is now configured to connect to the iSCSI target.

Configuring an iSCSI Initiator in Windows

Use QConvergeConsole CLI to configure the iSCSI initiator for Windows.

To configure a Windows iSCSI initiator:

1. Access the QConvergeConsole CLI either by double-clicking the QCC CLI desktop icon or by entering

qaucli in the CMD window.

2. On the QConvergeConsole CLI Main Menu, select 2, Adapter Configuration.

3. On the Adapter Type Configuration Selection menu, select 1, CNA Configuration.

4. On the Converged Network Adapter (CNA) Protocol Type Selection menu, select 1, CNA iSCSI

Configuration.

5. On the Converged Network Adapter (CNA) iSCSI Configuration menu, select 3, Port IP Settings.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 131 132

Keine Kommentare

Lenovo ThinkServer RD540 Bedienungsanleitung Seite 104