Lenovo ThinkServer RD540 Bedienungsanleitung PDF herunterladen (Seite 15)

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page xv

Quick Start

This Quick Start section describes how to install and configure your new QLogic converged network

adapter in three simple steps:

• Step 1. Install the Adapter Hardware

• Step 2. Install the Adapter Drivers

• Step 3. Install QConvergeConsole

• Step 4. Update the Flash

Step 1. Install the Adapter Hardware

To install the adapter hardware, you need to open the computer and locate the appropriate bus slot. If

necessary, consult your computer system manual for instructions on how to remove the computer cover.

Follow these steps to install the adapter hardware:

1. Power off the computer and all attached devices such as monitors, printers, and external components.

2. Disconnect the power cable.

3. Remove the computer cover and find an empty PCIe

x8 (or larger) bus slot.

4. Pull out the slot cover (if any) by removing the screw or releasing the lever.

5. Install the low-profile bracket (if required).

6. Grasp the adapter by the top edge and seat it firmly into the appropriate slot (see Figure i).

Figure i Illustration of Server Motherboard and Slots

7. Refasten the adapter’s retaining bracket using the existing screw or lever.

8. Close the computer cover.

9. Plug the appropriate Ethernet cable (either copper or optical) into the adapter.

Caution: Keep the adapter in the antistatic bag until installation. The adapter contains parts that can

be damaged by electrostatic discharge (ESD). Before handling the adapter, use standard

methods to discharge static electricity. Place the adapter on the bag when examining it.

Retain the bag for future use.

ADAPTER

RETAINING

BRACKET

LEVER

SLOT COVERS

SYSTEM

CHASSIS

PCI EXPRESS x8

(OR LARGER) SLOT

REQUIRED FOR

QLOGIC ADAPTERS.

SCREW

ADAPTER

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 131 132

Keine Kommentare

Lenovo ThinkServer RD540 Bedienungsanleitung Seite 15