Lenovo ThinkServer RD540 Bedienungsanleitung PDF herunterladen (Seite 97)

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 79

For every test performed, the diagnostic utility shows the following data:

• Total number of attempts

• Number of successful completions

• Number of failures

You can either perform all tests in succession, or perform only specific tests specified by the preceding

command-line parameters.

You can run additional diagnostics in the CLI as listed in the following table. To determine the

cna_port_inst, issue the qaucli -nic –i command as shown in Table 16.

Windows Diagnostic Test Descriptions

This section provides descriptions of the following Windows diagnostic tests:

• “Hardware Test” on page 79

• “Register Test” on page 79

• “Interrupt Test” on page 80

• “Loopback Test” on page 80

• “Link Test” on page 80

Hardware Test The hardware test checks the status of various hardware blocks, including DMA engines,

receive engine, and on-board processor meta cores.

Table 16. Running Windows Diagnostic Tests in the CLI

Test Type Command

External Loopback qaucli -nic -extloopback <cna_port_inst> <tests_num> <on_error>

Where <tests_num> specifies the number of tests, 1–65535, and <on_error> is

either 0=Ignore or 1=Abort.

Note: This test requires a pass-through module to be configured for both ports. Test

runs between two ports. Single port loopback is not supported.

Flash qaucli –nic –testflash [cna_port_inst]

Hardware qaucli –nic –testhw [cna_port_inst]

Internal Loopback qaucli -nic -intloopback <cna_port_inst> <tests_num> <on_error>

Where <tests_num> specifies the number of tests, 1–65535, and <on_error> is

either 0=Ignore or 1=Abort

Interrupt qaucli –nic –testinterrupt [cna_port_inst]

Link qaucli -nic -testlink [cna_port_inst]

Ping (IPv4) qaucli -nic -ping <cna_port_inst> <hostname_or_IPv4> [<count> <pock-

et_size> <timeout_ms> <TTL>]

Where the default values are count=5, pocket_size=525, time-

out_ms=1000, and TTL=30

Transceiver DMI Data qaucli -nic -trans [cna_port_inst]

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 131 132

Keine Kommentare

Lenovo ThinkServer RD540 Bedienungsanleitung Seite 97