Lenovo 1165 Bedienungsanleitung PDF herunterladen (Seite 31)

Enabling or disabling a device

This section provides instructions on how to enable or disable user access to a

device.

USB Setup Use this option to set up USB connectors.

SATA Controller When this option is set to Disabled, all devices connected to the

SATA connectors (such as the hard disk drive or the optical drive)

are disabled and will not be displayed in the system configuration.

To enable or disable a device, do the following:

1. Start the Setup Utility program. See “Starting the Setup Utility program” on

page 21.

2. From the Setup Utility program main menu, select Devices.

3. Depending on the device you want to enable or disable, do one of the

following:

v Select USB Setup and follow the instructions on the screen to enable or

disable the USB connector(s) of your choice.

v Select ATA Drives Setup → SATA Controller to enable or disable the devices

connected to the SATA connectors on the system board.

4. Select the desired settings and press Enter.

5. Press Esc to return to the Setup Utility program main menu. You might have to

press Esc several times.

6. Press F10 to save the new settings and exit the Setup Utility program.

Notes:

a. If you do not want to save the settings, select Exit → Discard Changes and

Exit.

b. If you want to return to the default settings, press F9 or select Exit → Load

Optimal Defaults.

Selecting a startup device

If your computer does not start up from a device (such as a hard disk drive or the

disc in an optical drive) as expected, do one of the following to select the desired

startup device.

Selecting a temporary startup device

This section provides instructions on how to select a temporary startup device. You

can use the instructions in this section to start up from any startup device.

Note: Not all discs and hard disk drives are bootable.

To select a temporary startup device, do the following:

1. Turn off your computer.

2. Repeatedly press and release the F12 key when turning on the computer. When

the Startup Device Menu opens, release the F12 key.

3. Select the desired startup device on the Startup Device Menu and press Enter

to begin.

Chapter 4. Using the Setup Utility program 23

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Keine Kommentare

Lenovo 1165 Bedienungsanleitung Seite 31