Lenovo TS200V Bedienungsanleitung PDF herunterladen (Seite 59)

Replacing the rear fan assembly

Attention

Do not open your server or attempt any repair before reading and

understanding the “Safety” on page v and the Safety Information book. To

obtain a copy of the Safety Information book, go to:

http://www.lenovo.com/support

This section provides instructions on how to replace the rear fan assembly.

To replace the rear fan assembly, do the following:

1. Remove all media from the drives and turn off all attached devices and the

server. Then, disconnect all power cords from electrical outlets and disconnect

all cables that are connected to the server.

2. Remove the server cover. See “Removing the server cover” on page 18.

3. Locate the rear fan assembly. See “Internal components” on page 15.

4. Disconnect the rear fan assembly cable from the system fan connector on the

system board. See “System-board internal connectors” on page 14.

5. The rear fan assembly is attached to the chassis by four rubber mounts.

Remove the rear fan assembly by cutting the rubber mounts and gently pulling

the rear fan assembly out of the chassis.

6. Install the new rear fan assembly by aligning the new rubber mounts with the

corresponding holes in the chassis and push the rubber mounts through the

holes.

Note: The new rear fan assembly will have four new rubber mounts attached.

Figure 31. Removing the rear fan assembly

Chapter 5. Installing or replacing customer replaceable units 43

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 95 96

Keine Kommentare

Lenovo TS200V Bedienungsanleitung Seite 59