Lenovo TS200V Bedienungsanleitung PDF herunterladen (Seite 50)

Replacing the heat sink and fan assembly

Attention

Do not open your server or attempt any repair before reading and

understanding the “Safety” on page v and the Safety Information book. To

obtain a copy of the Safety Information book, go to:

http://www.lenovo.com/support

This section provides instructions on how to replace the heat sink and fan

assembly.

CAUTION:

The heat sink and fan assembly might be very hot. Turn off the server and wait

three to five minutes to let the server cool before removing the server cover.

To replace the heat sink and fan assembly, do the following:

1. Remove all media from the drives and turn off all attached devices and the

server. Then, disconnect all power cords from electrical outlets and disconnect

all cables that are connected to the server.

2. Remove the server cover. See “Removing the server cover” on page 18.

3. Lay the server on its side for easier access to the system board.

4. Locate the heat sink and fan assembly. See “System-board internal connectors”

on page 14.

5. Disconnect the heat sink and fan assembly cable from the microprocessor fan

connector on the system board. See “System-board internal connectors” on

page 14.

34 Installation and User Guide

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 95 96

Keine Kommentare

Lenovo TS200V Bedienungsanleitung Seite 50