Lenovo 5354 Bedienungsanleitung PDF herunterladen (Seite 46)

v Be significantly different from your previous passwords

Set User Password

After you have set a user password using the Set User Password option, the user is

prompted to type a valid password each time the computer is turned on. The

computer cannot be used until a valid password is typed in. For more information

on how to set a password, see “Setting, changing, and deleting a password.”

Change Supervisor Password

The Change Supervisor Password option enables you to set a password, which

deters unauthorized users from changing configuration settings. If you are

responsible for maintaining the settings of several computers, you might want to

set a supervisor password. For more information on how to set a password, see

“Setting, changing, and deleting a password.”

After you have set a supervisor password, a password prompt is displayed each

time you try to access the Setup Utility program. You cannot access the Setup

Utility program until a valid password is typed in.

If you have set both the user password and the supervisor password, you can type

either password. However, to change any configuration settings, you must use

your supervisor password.

Setting, changing, and deleting a password

To set, change, or delete a password, do the following:

1. Start the Setup Utility program. See “Starting the Setup Utility program” on

page 37.

2. From the Setup Utility program main menu, select Security.

3. Follow the instructions displayed on the screen to set, change, or delete a

password.

Note: A password can be any combination of seven to ten alphabetic and

numeric characters. For more information, see “Password considerations”

on page 37.

Enabling or disabling a device

This section provides instructions on how to enable or disable user access to the

devices connected to the SATA connectors on the system board.

SATA#1 Configuration When this feature is set to Disabled, all devices connected to the

SATA connectors (such as hard disk drive or optical drive) are

disabled and will not be displayed in the system configuration.

To enable or disable a device, do the following:

1. Start the Setup Utility program. See “Starting the Setup Utility program” on

page 37.

2. Depending on your model type, select Device or select Device → ATA Drives

Setup from the Setup Utility program main menu.

3. Select the desired devices and settings, and press Enter.

38 User Guide

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 67 68

Keine Kommentare

Lenovo 5354 Bedienungsanleitung Seite 46