Lenovo 5354 Bedienungsanleitung Seite 28

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 68
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 27
4. Place the new heat sink on the system board so that the four screws are aligned
with the four corresponding mounting studs on the system board.
5. Alternate tightening each screw a small and equal amount until the heat sink is
secured to the system board. Do not over-tighten the screws.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the replacement, go to “Completing the parts replacement” on
page 24.
Replacing the system fan assembly
Attention
Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide,goto:
http://www.lenovo.com/support
This section provides instructions on how to replace the system fan assembly.
To replace the system fan assembly, do the following:
1. Remove the computer cover. See “Removing the computer cover” on page 12.
2. Disconnect the system fan assembly cable from the system fan connector on the
system board. See “Locating parts on the system board” on page 10.
3. You might have to remove the hard disk drive to gain access to the system fan
assembly. See “Replacing the hard disk drive” on page 15.
4. Break or cut the rubber mounts that secure the system fan assembly to the
chassis. Then, remove the system fan assembly out of the computer.
5. Install the two new short rubber mounts to the new system fan assembly.
Figure 17. Removing the system fan assembly
20 User Guide
Seitenansicht 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare