Lenovo 6434 Bedienungsanleitung PDF herunterladen (Seite 48)

6. Touch the static-protective package that contains the drive to any unpainted

metal surface on the server; then, remove the drive from the package and

place it on a static-protective surface.

7. Set any jumpers or switches on the drive according to the documentation that

comes with the drive.

8. Remove the drive retainer clip4 from the side of the drive cage of bays 1 or

2. Slide the drive retainer clip to the right to remove it from the drive cage;

then, snap the drive retainer clip into the screw holes on the side of the drive.

9. Slide the drive into the bay.

Note: A tape drive can be installed in bay 1 or 2.

10. Connect one end of the applicable signal cable into the rear of the drive and

make sure that the other end of this cable is connected into the applicable

connector on the system board.

11. Route the signal cable so that it does not block the airflow to the rear of the

drives or go over the microprocessor and dual inline memory modules

(DIMMs).

12. If you have another drive to install or remove, do so now.

13. Connect the power cable to the rear of the drive. The connectors are keyed

and can be inserted only one way.

you have other devices to install or remove, do so now; otherwise, go to

“Completing the installation” on page 50.

34 ThinkServer TS100 Types 6431, 6432, 6433, and 6434: User Guide

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 95 96

Keine Kommentare

Lenovo 6434 Bedienungsanleitung Seite 48