Lenovo THINKSERVER RD230 Bedienungsanleitung PDF herunterladen (Seite 51)

5. Touch the static-protective package that contains the new memory module to

any unpainted metal surface on the outside of the server. Then, remove the

new memory module from the package.

6. Position the new memory module over the memory slot. Make sure that the

notch 1 on the new memory module is aligned with the key 2 in the

memory slot. Then, press the new memory module straight down into the

memory slot until the retaining clips close and the new memory module snaps

into position.

Note: If there is a gap between the memory module and the retaining clips, the

memory module has not been correctly installed. Open the retaining

clips, remove the memory module, and then reinstall it into the slot.

7. To complete the installation, go to “Completing the parts replacement” on page

87.

Removing a memory module

Attention

Do not open your server or attempt any repair before reading and understanding the Safety

Information and the Warranty and Support Information on the ThinkServer Documentation DVD

that comes with your product, and “Guidelines” on page 37. To obtain a copy of the

publications, go to:

http://www.lenovo.com/support

This section provides instructions on how to remove a memory module.

Figure 9. Opening the retaining clips of the memory slot

Figure 10. Installing the memory module

Chapter 5. Installing, removing, or replacing hardware 45

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 147 148

Keine Kommentare

Lenovo THINKSERVER RD230 Bedienungsanleitung Seite 51