Lenovo Secure Managed Client Bedienungsanleitung PDF herunterladen (Seite 49)

Chapter 7. Populating a base image

All new user images must be created from a base image. If the base image contains

a valid Sysprep image, deploying a new user is a straightforward process. If the

base image is blank allocated space, each new user will also receive blank space.

Although this is valid, it does not utilize the full power of the Secure Managed

Client solution.

This section discusses the main methods to deploy or install the base image onto

the storage array for future creation of new users.

Using bootable CD/DVD media

This method is used to boot the client to the ULOS, connect the client to the base

image on the storage array, and boot the media to install the desired image. The

bootable media can be a DVD containing an ImageX image or Ghost image, a set

of Recovery CDs, or an operating system installation CD. However, if network

access is required, use the SMCWinPE.iso CD provided in the LANDesk

installation package. The SMCWinPE.iso is a Windows PE CD that contains the

network drivers needed to connect to the network from a client device. This

Windows PE CD also contains a graphical user interface (GUI) that enables the

contents of the local drive on the local physical hard disk drive to be copied to the

base image.

Notes:

1. ImageX is a command-line tool that captures, modifies, and applies installation

images for deployment in a manufacturing or corporate environment. ImageX

does not do a sector-by-sector copy. This results in a much smaller image file

than other clone tools such as Ghost.

2. Ghost is an image tool that clones a hard disk drive using sector-by-sector

copying.

You can use any device that you would normally use to deploy an operating

system image. The image can be located on a set of DVDs, a network share, or the

local physical hard disk drive.

To deploy the desired image, complete the following steps:

1. Create a new base image (see Chapter 6, “Secure Managed Client image

creation and tuning,” on page 23. Determine how much space this image will

require. The new image appears in the Pending folder. Do not activate this

image until you have confirmed this image is ready to create new users.

2. Insert the bootable media and boot the client to the ULOS. Do not enter any

credentials at this point.

3. From the Network view, expand the appropriate LANDesk core. Select Devices

-> All Devices. Match up the name on the list to the serial number which is

usually found on the outside of the box.

4. Drag the device over to the new pending base image that was just created.

5. A Boot SMC Client dialog box appears. Make sure that Include CDROM in

boot order is checked and click Boot.

6. The client ULOS disappears, connects to the blank base image on the storage

array, and begins booting to the media.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Lenovo Secure Managed Client Bedienungsanleitung Seite 49

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerhardware Lenovo Secure Managed Client