Lenovo TS200V Bedienungsanleitung PDF herunterladen (Seite 52)

10. Connect the heat sink and fan assembly cable to the microprocessor fan

connector on the system board. See “System-board internal connectors” on

page 14.

What to do next:

v To work with another piece of hardware, go to the appropriate section.

v To complete the replacement, go to “Completing the parts replacement” on

page 44.

Replacing the primary hard disk drive

Attention

Do not open your server or attempt any repair before reading and

understanding the “Safety” on page v and the Safety Information book. To

obtain a copy of the Safety Information book, go to:

http://www.lenovo.com/support

This section provides instructions on how to replace the primary hard disk drive.

To replace the primary hard disk drive, do the following:

1. Remove all media from the drives and turn off all attached devices and the

server. Then, disconnect all power cords from electrical outlets and disconnect

all cables that are connected to the server.

2. Remove the server cover. See “Removing the server cover” on page 18.

3. Locate the primary hard disk drive. See “Internal drives” on page 16.

4. Disconnect the signal cable and the power cable from the rear of the hard disk

drive.

36 Installation and User Guide

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 95 96

Keine Kommentare

Lenovo TS200V Bedienungsanleitung Seite 52