Lenovo RD120 Bedienungsanleitung PDF herunterladen (Seite 71)

4. Remove the microprocessor air baffle (see “Removing the microprocessor air

baffle” on page 34).

5. Install the VRM in the VRM connector.

a. Touch the static-protective package containing the VRM to any unpainted

metal surface on the outside of the server. Then, remove the VRM from the

package.

b. Turn the VRM so that the keys align correctly with the VRM connector 1.

c. Firmly press the VRM straight down into the connector by applying

pressure on both ends of the VRM simultaneously.

d. Make sure that the retaining clips are in the locked position when the VRM

is firmly seated in the connector.

6. Locate the second microprocessor connector on the system board.

7. Rotate the heat-sink release lever to the fully open position.

8. Lift the heat-sink filler out of the server.

9. Install the microprocessor:

a. Touch the static-protective package that contains the microprocessor to any

unpainted metal surface on the server. Then, remove the microprocessor

from the package.

b. Remove the protective dust cover 1, tape, or label from the surface of

the microprocessor socket, if one is present.

Chapter 2. Installing optional devices 57

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 117 118

Keine Kommentare

Lenovo RD120 Bedienungsanleitung Seite 71