Lenovo IdeaCentre K210 Bedienungsanleitung

www.lenovo.comVersion 1.0WORLDWIDE PARTNER31032753IdeaCentre KHardware Replacement Guide31032753_HRG_FM_EN.indd 1 2007.12.10 3:54:04 PM

7Hardware Replacement GuideX-1X-2DVIKey to symbols used in the above illustrations of the rear of the chassis: ——— Power Connector: To supply power to

8Hardware Replacement Guide ——— Parallel Connector: To connect devices requiring a parallel connection. X-1 —— On-board VGA Card Connector: To connec

9Hardware Replacement Guide(some models equipped with this connector) —— Voltage: selection switch (Some models are equipped with this switch) 115 23

10Hardware Replacement GuideMicroprocessor and heat sink Clear CMOS/Recovery jumper Microprocessor fan connector Front USB connectors (2)Memory connec

11Hardware Replacement GuideReplacing hardwareAttentionDo not remove the computer cover or attempt any repair before reading the “Important safety inf

12Hardware Replacement Guide5. Pull down the switch at the rear of the chassis and slide the computer cover to the rear to remove.Removing and replac

13Hardware Replacement Guide3. To reinstall the bezel, align the plastic tabs on the bottom of the bezel with the corresponding holes in the chassis,

14Hardware Replacement GuideTo replace the power supply: 1. Remove the computer cover. Refer to “Removing the computer cover”. Note: For this proced

15Hardware Replacement GuideReplacing the heat sink assembly AttentionDo not remove the computer cover or attempt any repair before reading the “Impor

16Hardware Replacement Guide8. Install the heat sink and fan assembly on the heat sink retention bracket. 9. Reconnect the disconnected cables to th

Hardware Replacement Guide31032753 IdeaCentre K_HRG_EN.indd 31 2007.12.10 3:53:38 PM

17Hardware Replacement Guide4. Position the new memory module over the memory connector. Make sure the notch on the memory aligns correctly with th

18Hardware Replacement Guide2. At the rear of the computer, press the release button to open the adapter latch and remove the adapter by pulling

19Hardware Replacement Guide4. Ensure the adapter is fully seated into the adapter connector. 5. At the rear of the computer, pivot the adapter latc

20Hardware Replacement GuideAfter the Graphic Adapter is installed , install the bracket as the following:1. Install the bracket into the chassis so

21Hardware Replacement GuideReplacing the hard disk drive AttentionDo not remove the computer cover or attempt any repair before reading the “Importan

22Hardware Replacement Guide3. Use the blue handle to remove hard disk drive from drive bay. 4. Slide the new hard disk drive into the drive bay. 5.

23Hardware Replacement Guide3. Disconnect the signal and power cables from the rear of the optical drive. 4. Press the release button and remove the

24Hardware Replacement GuideTo replace the system fan assembly: 1. Remove the computer cover. Refer to “Removing the computer cover”.2. Locate the s

25Hardware Replacement Guide6. Pull on the tips of the rubber mounts until the fan assembly is in place. 7. Connect the system fan assembly cable to

26Hardware Replacement GuideTo replace the keyboard: 1. Remove any media (diskettes, CDs, or tapes) from the drives, shut down your operating system,

ContentsOverview ... 1Chapter 1 Locations ...

27Hardware Replacement Guide4. Disconnect the failing mouse cable from the computer. 5. Connect the new mouse cable to the connector. 6. Refer to t

28Hardware Replacement GuideTo complete the part installation: 1. Ensure that all components have been reassembled correctly and that no tools or loo

29Hardware Replacement GuideAppendix. StatementThanks for using Lenovo products.Carefully read all documents shipped with your computer before you ins

30Hardware Replacement GuideLenovo is trademark of Lenovo (Beijing ) Co., Ltd.Microsoft is the registered trademark of Microsoft Corporation.Microsoft

1Hardware Replacement GuideOverviewThis guide is intended to be used by customers who are replacing Customer Replaceable Units (CRUs) as well as train

2Hardware Replacement GuideSafety information for replacing FRUs Do not attempt any repair before reading the “Important safety information” in the Ha

3Hardware Replacement Guide• Before you replace a new part, touch the static-protective package containing the part to a metal expansion-slot cover o

4Hardware Replacement GuideLocationsChapterThis chapter provides illustrations to help locate the various connectors, controls and components of the c

5Hardware Replacement GuideLocating connectors on the front of the computer The following illustration shows the location of connectors on the front o

6Hardware Replacement GuideF-2 Digital connector (open the Digital Panel)[D-5][D-1][D-2][D-3][D-4][D-2]MS/Pro/Duo/ProDuoCF/I/II/MDxDSD/Mini/HC/MiniHCM