Lenovo ThinkVision L190 Bedienungsanleitung PDF herunterladen (Seite 19)

Normally, you can complete the setup procedure using Automatic Image setup;

however, if your screen image is still distorted after you perform Image setup or

the setup CD does not run on your system, perform Manual Image setup.

To manually adjust the image setting, do the following:

1. Turn on the monitor and wait approximately 15 minutes for it to warm

up.

2. Display the image you most frequently use on the screen.

3. Press the OSD Enter button " " at the bottom of the monitor to display

the initial OSD menu.

4. Use the Right Arrow button " " to select the Image setup icon " "

and press the OSD Enter button " " to access the function.

5. Use the Right Arrow button " ", to select manual. Press the OK

button " " twice to select clock.

6. Use the Arrow buttons to manually adjust to correct for jitter or noise in

the image. Press the OK button " ".

7. Press OK " " and use the Arrow buttons to adjust phase, then press

OK " ".

Press OK " " again to save and exit. Then press Exit button " "

twice to exit OSD.

You have completed the monitor setup.

ENGLISH

If the monitor is in standby

mode, it might automatically

turn off while you are waiting

for it to warm up.

Manual Image setup

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Keine Kommentare

Lenovo ThinkVision L190 Bedienungsanleitung Seite 19