Lenovo 6437 Bedienungsanleitung PDF herunterladen (Seite 38)

7. At a downward angle, insert the free end of the adapter under the tab on the

mounting bracket, aligning the holes in the adapter with the posts on the

mounting bracket. Rotate the rear of the adapter into the rear mounting

bracket, aligning the holes in the adapter with the posts on the rear mounting

bracket.

8. Press the Remote Supervisor Adapter II SlimLine firmly into the connector and

make sure that all tabs on both mounting brackets secure the adapter in place.

Attention: Incomplete insertion might cause damage to the server or the

adapter.

9. If a three-quarter-length adapter is installed in expansion slot 1 on the

riser-card assembly, remove it. You can replace it with a half-length adapter if

you choose to do so.

10. Reinstall the riser-card assembly. Make sure that the riser-card assembly is

fully seated in the riser-card connectors on the system board.

11. If you have installed an optional PCI-X riser-card assembly, reconnect the

riser-card power cable 1 to the riser-card assembly.

See

the documentation that comes with the Remote Supervisor Adapter II SlimLine

for information about installing the firmware and configuring the adapter. Create a

backup copy of the configuration so that if you have to replace the adapter in the

future you can restore the configuration.

If you have other devices to install, do so now. Otherwise, go to “Completing the

installation.”

Completing the installation

To complete the installation, complete the following steps:

1. Install the cover. See “Installing the cover” on page 25 for more information.

2. Install the server in the rack cabinet. See the Rack Installation Instructions that

come with the server for detailed information about how to install the server in a

rack cabinet.

24 ThinkServer RS110 Types 6435, 6436, 6437, and 6438: Installation Guide

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 87 88

Keine Kommentare

Lenovo 6437 Bedienungsanleitung Seite 38