Lenovo IdeaPad U400 Bedienungsanleitung PDF herunterladen (Seite 20)

Chapter 3. Learning the basics

Setting the Hotkey Mode

By default, the hotkey functions are accessible by pressing one single function key (F1~F12).

However, you can disable the Hotkey mode in the BIOS setup interface. To disable the Hotkey

mode, do the following:

Restart the computer. Press Fn + F2 to open the BIOS setup interface right after the Lenovo

logo appears.

In the BIOS setup interface, open the <Configuration> menu, and change the setting of

<Hotkey mode> from Enable to Disable (or, change the setting of <Hotkey Switch> from

Hotkey mode to Legacy Mode (for 400 only)).

Note: If Lenovo <Fast Boot> has been enabled for your computer, you can press Fn + F2 at startup to

open the BIOS setup interface. In such case, turn off the computer, press the OneKey Rescue

System button, and then select <Enter Setup> to open the BIOS setup interface.

Note: In the Legacy mode, you may access the hotkey function by pressing the appropriate hotkey

while holding the Fn key.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

Keine Kommentare

Lenovo IdeaPad U400 Bedienungsanleitung Seite 20