Lenovo ThinkServer TD100x Bedienungsanleitung PDF herunterladen (Seite 75)

4. Select the startup device.

The

next time the server is started, it returns to the startup sequence that is set in

the Configuration/Setup Utility program.

Enabling the Broadcom Gigabit Ethernet Utility program

The Broadcom Gigabit Ethernet Utility program is part of the BIOS. You can use it

to configure the network as a startable device, and you can customize where the

network startup option appears in the startup sequence. Enable and disable the

Broadcom Gigabit Ethernet Utility program from the Configuration/Setup Utility

program.

To enable the Broadcom Gigabit Ethernet Utility program, complete the following

steps:

1. Turn on the server.

2. When the prompt Press F1 for Configuration/Setup appears during startup,

press F1.

3. From the Configuration/Setup Utility main menu, select Devices and I/O Ports

and press Enter.

4. Select Planar Ethernet and use the Right Arrow (→) key to set it to Enabled.

5. Select Save Settings and press Enter.

Configuring the Broadcom Gigabit Ethernet controller

The Ethernet controller is integrated on the system board. It provides an interface

for connecting to a 10-Mbps, 100-Mbps, or 1-Gbps network and provides full-duplex

(FDX) capability, which enables simultaneous transmission and reception of data on

the network. If the Ethernet ports in the server support auto-negotiation, the

controller detects the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T)

and duplex mode (full-duplex or half-duplex) of the network and automatically

operates at that rate and mode.

You do not have to set any jumpers or configure the controller. However, you must

install a device driver to enable the operating system to address the controller. To

find updated information about configuring the controller, complete the following

steps.

Note: Changes are made periodically to the Lenovo Web site. The actual

procedure might vary slightly from what is described in this document.

1. Go to: http://www.lenovo.com/support.

2. From Family list, select ThinkServer TD100 or TD100x, and click Continue.

3. Click Downloads and drivers to download firmware updates.

Chapter 4. Configuring the server 59

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 123 124

Keine Kommentare

Lenovo ThinkServer TD100x Bedienungsanleitung Seite 75