Lenovo ThinkCentre M90 Betriebsanweisung PDF herunterladen (Seite 76)

To run the diagnostic program from a diagnostic disc that you created, do the

following:

1. Make sure the optical drive you want to use is set as the first boot device in the

startup device sequence. See “Selecting a startup device” on page 59.

2. Make sure the computer is turned on and then insert the disc into the optical

drive. The diagnostic program opens.

Note: You can insert the disc into the optical drive when you are setting the

startup device sequence. However, if you insert the disc into the optical

drive when you have already entered the operating system, you need to

restart the computer to access the diagnostic program.

3. Follow the instructions on the screen to select the diagnostic test you want to

run.

Note: For additional help, press the F1 key.

4. Remove the diagnostic disc from the optical drive when you complete the

diagnostic process.

Cleaning an optical mouse

This section provides instructions on how to clean an optical mouse.

An optical mouse uses a LED and an optical sensor to navigate the pointer. If the

pointer on the screen does not move smoothly with the optical mouse, you might

need to clean the mouse.

To clean an optical mouse, do the following:

1. Turn off your computer.

2. Disconnect the mouse cable from the computer.

3. Turn the mouse upside down to check the lens.

a. If there is a smudge on the lens, gently clean the area with a plain

cotton-tipped swab.

b. If there is debris in the lens, gently blow the debris away from the area.

4. Check the surface on which you are using the mouse. If you have a very

intricate picture or pattern beneath the mouse, it may be difficult for the digital

signal processor (DSP) to determine changes in the mouse position.

5. Reconnect the mouse cable to the computer.

6. Turn your computer back on.

68 User Guide

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 89 90

Keine Kommentare

Lenovo ThinkCentre M90 Betriebsanweisung Seite 76