Lenovo Personal Computer 6423 Bedienungsanleitung PDF herunterladen (Seite 29)

3. Select the desired startup device from the Startup Device Menu and press Enter

to begin.

Note:

Selecting a startup device from the Startup Device menu does not

permanently change the startup sequence.

Selecting or changing the startup device sequence

To view or permanently change the configured startup device sequence, do the

following:

1. Start the Setup Utility program (see “Starting the Setup Utility program” on

page 19).

2. Select Startup → Startup Sequence, and see the information displayed on the

right side of the screen.

3. Select the devices for the Primary Startup Sequence, the Automatic Startup

Sequence, and the Error Startup Sequence.

4. Select Exit from the Setup Utility menu and then Save Settings or Save and

exit the Setup Utility.

If you have changed these settings and want to return to the default settings, select

Load Default Settings on the Exit menu.

Advanced settings

On some computer models, the Advanced settings menu includes a setting to

Enable/Disable HyperThreading. This feature works only with

HyperThreading-aware operating systems, such as Windows XP. The default

setting for HyperThreading is Enabled. However, if you select Set Defaults and

are using an operating system other than Windows XP, your computer

performance might be degraded. Therefore, you should always set

HyperThreading to Disabled unless you are sure your operating system supports

HyperThreading.

Exiting from the Setup Utility program

After you finish viewing or changing settings, press Esc to return to the Setup

Utility program menu (you might have to press Esc several times). If you want to

save the new settings, select Save Settings or Save and exit the Setup Utility.

Otherwise, your changes will not be saved.

Chapter 5. Using the Setup Utility 21

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 71 72

Keine Kommentare

Lenovo Personal Computer 6423 Bedienungsanleitung Seite 29