Lenovo IdeaPad S10 Bedienungsanleitung PDF herunterladen (Seite 31)

With a Supervisor password, you can get full control of the computer. It also can

be used as a power-on password if Password on boot is set to Enabled. Also,

when you enter the BIOS Setup Utility with a Supervisor password, you are

entitled to set all of the options.

v User password

If a User password is set and Password on boot is set to Enabled, a password

prompt appears when you turn on the computer. Unauthorized users cannot get

access to configuration data. You can also use the User password to enter the BIOS

Setup Utility, but only a part of the options can be set. User password can not be

set if Supervisor password is not set.

v Hard disk drive (HDD) passwords

Once an HDD password is set, you need to enter it to get access to the hard disk.

You can set the HDD password through Set Hard Disk Passwords in the BIOS

Setup Utility.

Note:

If you set passwords through the BIOS Setup Utility and put your computer into

standby mode by pressing Fn + F1, the following describes the behavior of the

computer when you bring it out of standby mode:

v You are prompted to enter the Windows log-on password rather than the User

password to resume operation.

v If an HDD password is assigned to any hard disk drive, the hard disk drive is

unlocked automatically when you resume operation.

set a Supervisor Password:

Only a system administrator is able to perform this procedure.

Chapter 2. Using your computer 23

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 179 180

Keine Kommentare

Lenovo IdeaPad S10 Bedienungsanleitung Seite 31