Lenovo 9211 Bedienungsanleitung PDF herunterladen (Seite 35)

Note: If you are installing a 3.5-inch hard disk drive you must use a

Universal Adapter Bracket, 5.25 to 3.5-inch. You can obtain this bracket

from a local computer retailer or by contacting the Customer Support

Center.

7. Reinstall the front bezel.

8. Slide the optical drive lock to the unlock position. See “Locating components”

on page 11.

9. If you are installing any type of drive other than a serial ATA hard disk drive,

make sure the drive that you are installing is set correctly as either a master

or a slave device.

Note: A serial ATA hard disk drive does not need to be set as either a master

or a slave device.

If you are installing an optical drive or a parallel ATA hard disk drive, set it as

a master device. Refer to the documentation that comes with your drive for

master/slave jumper information.

10. For a 3.5-inch drive, install the drive into the Universal Adapter Bracket, 5.25

to 3.5-inch.

11. Install the drive into the bay until it snaps into position.

12. Slide the optical drive lock 1 to the locked position.

13. Pivot the drive bay assembly upward to gain access to the cable connections.

14. Connect at “Connecting drives” on page 21.

Installing a diskette drive in bay 3

To install a diskette drive in bay 3, do the following:

1. Open the computer cover. See “Opening the cover” on page 10.

Chapter 1. Installing options 19

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 65 66

Keine Kommentare

Lenovo 9211 Bedienungsanleitung Seite 35