Lenovo ThinkServer TD340 Bedienungsanleitung PDF herunterladen (Seite 9)

LPe16000 Series HBA Installation Manual P007648-01A Rev. A

2. Installation

Preparing the HBA for Installation

2. Installation

The standard LPe16000/16002 HBA can be connected to fiber optic cables.

Preparing the HBA for Installation

The Emulex LPe16000 and LPe16002 host bus adapters (HBAs) use removable optical

transceivers. If you need to change the bracket for HBA installation, you must first

remove the optical transceiver(s), if installed, from the housing (cage). This procedure

explains how to install the HBA and, if necessary, how to remove the transceiver and

bracket safely.

Each HBA is shipped with several numbers clearly marked on the board. these include

 IEEE Address

 World Wide Name (WWN)

 Serial number

The IEEE address is a unique 64-bit identifier that you use when configuring your

system. The FC industry uses the World Wide Name (WWN) derived from the IEEE

address for FC connectivity. If the adapter has two ports, there are two IEEE addresses

and two WWNs. Use the serial number when communicating with Emulex. Record

these numbers before installation.

To install the HBA:

1. Turn off the computer if hotplug is not supported on the server. See your server

documentation to see if it supports Hot Plug/Hot Swap of PCIe adapter cards.

Remove the HBA.

Note: The HBA comes with a standard PCIe bracket installed. A low-profile

bracket is included in the box with the HBA. The low-profile mounting

bracket is shorter than the standard bracket; approximately 3.11 inches

(7.9 cm) compared to 4.75 inches (12.06 cm) long.

2. For the standard LPe16000/16002 HBA, if you want to change the bracket to a low

profile version, follow steps 4–12; otherwise, proceed to “Installing the Adapter” on

page 11.

3. Some standard LPe16000/16002 HBAs come with optical transceivers embedded in

their cage assemblies. These optical transceivers must be removed before the

bracket can be removed. If the HBA contains optical transceivers, continue with the

following steps; otherwise, proceed to step 7.

CAUTION: This is a delicate operation. Take care not to damage the optical

transceiver.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Keine Kommentare

Lenovo ThinkServer TD340 Bedienungsanleitung Seite 9