Lenovo Secure Managed Client Bedienungsanleitung PDF herunterladen (Seite 21)

Chapter 3. Getting Started

In this chapter, you are shown how to plan and install your Secure Managed Client

(SMC) - Storage Array into an industry standard 48.26-cm (19-inch) rack cabinet.

CAUTION:

When connecting the SMC - Storage Array, use only the power cords supplied or

power cords that match the specification quoted in the Safety and Warranty Guide.

Planning your installation

Before installing the SMC - Storage Array, familiarize yourself with the

configuration requirements listed in the following table.

CAUTION:

Installation procedures should be performed by trained personnel only.

Table 3. Configuration requirements

Module Location

Drive bays All drive bays must be installed with either

a drive carrier module or a dummy drive

carrier module. No bays should be left

empty. A minimum of 1 drive must be

installed.

Power supply One PSU can be installed. A blanking plate

must be installed to cover the empty (top)

slot.

Cooling fans Ten fans, housed in a cooling cage, are

located centrally within the enclosure

between the drive bays and the server

board.

PCI cards Up to six PCI cards can be installed in a

vertical orientation. Currently, only the two

outer card slots are used in the standard

configuration, installed with an Intel

RAID

Controller SRCSAS144E and an Intel

Intelligent AXXRIBBU1 Battery Backup Unit.

When not in use, the four empty PCI slots

must be installed with blanking plates.

Drive bay numbering convention

The drive bay numbering convention is as follows.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Keine Kommentare

Lenovo Secure Managed Client Bedienungsanleitung Seite 21