Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 34)

Using the Configuration/Setup Utility program

The Configuration/Setup Utility program is part of the BIOS code. You can use it to:

v Change interrupt request (IRQ) settings

v Change the startup drive sequence

v Configure serial-port assignments

v Enable USB keyboard and mouse support

v Resolve configuration conflicts

v Set the date and time

v Set passwords and security settings

To start the Configuration/Setup Utility program, complete the following steps:

1. Turn on the server.

2. When the prompt Press F1 for Configuration/Setup appears, press F1. If an

administrator password has been set, you must type the administrator password

to access the full Configuration/Setup Utility menu.

3. Follow the instructions on the screen.

See the User Guide on the ThinkServer Documentation DVD for more detailed

information about the Configuration/Setup Utility program.

Using the RAID configuration programs

Note: RAID options and HostRAID are not supported on the SCO 6.0 and

UnixWare 7.14 operating systems.

Use the IBM ServeRAID Configuration Utility program, Adaptec RAID Configuration

Utility program, and ServeRAID Manager to configure and manage redundant array

of independent disks (RAID). Be sure to use these programs as described in this

document.

The ServeRAID 8k-l SAS Controller that comes with the TD100 server (hot-swap

SAS and hot-swap SATA models) enables you to configure multiple physical SAS or

SATA hard disk drives to operate as logical drives in a disk array. The server comes

with a CD containing the ServeRAID Manager program, which you can use to

configure the ServeRAID 8k-l SAS Controller. If your server comes with an

operating system installed, such as Microsoft Windows 2000 Datacenter Server, see

the software documentation that comes with the server for configuration information.

Use these programs to perform the following tasks:

v Perform a low-level format on a hard disk drive

v View or change IDs for attached devices

v Set protocol parameters on hard disk drives

v Monitor operation of the RAID controller

v Configure a redundant array of independent disks (RAID) array

v View or change the RAID configuration and associated devices

Consider the following information when using the RAID configuration programs to

configure and manage arrays:

16 ThinkServer TD100 and TD100x: Hardware Maintenance Manual

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 253 254

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 34