Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 224)

v Follow the suggested actions in the order in which they are listed in the Action column until the problem

is solved.

v See Chapter 3, “Parts listing, TD100 Types 6398, 6399, 6419, 6429, 4203, and 4206,” on page 25 to

determine which components are customer replaceable units (CRU) and which components are field

replaceable units (FRU).

v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a

trained service technician.

System-error log message Action

Alert not accepted from system x; type:y,

sender’s ID:z

Information only.

ASM Reset -- reason unknown Information only.

ASM Reset due to x, Instruction Fault: y Information only.

ASM Reset due Watchdog timeout Information only.

ASM Reset was caused by restoring default

values

Information only.

ASM Reset was initiated by the user Information only.

Cable: Service processor not present

1. Check the pins and connectors on the cable that connects the

Remote Supervisor Adapter II SlimLine or other service

processor adapter to the Remote Supervisor Adapter SlimLine

connector on the system board (see “System-board option

connectors” on page 12 for the location of the connector).

2. Reseat the cable (both ends) from the Remote Supervisor

Adapter II SlimLine or other service processor adapter to the

Remote Supervisor Adapter SlimLine connector on the system

board.

Configuration error recovery on the Inter-connect

network

Information only.

CPU x over temperature

1. Make sure that the heat sink has good airflow and is not

obstructed.

2. Reseat the following components:

a. Heat sink cable

b. (Trained service technician only) Heat sink

DASD controller removal

1. Make sure that the onboard SAS/SATA controller cable is not

damaged.

2. Reseat the onboard SAS/SATA controller cable.

3. Replace the onboard SAS/SATA controller cable.

DHCP failure,no IP@ assigned-

RETRYING!,rc=xxx,count=yyy

Information only.

Dialback failed for userid w. Could not connect

at phone number x, y, z

Information only.

ENET[eee] DHCP-

HstNme=a,DN=b,IP@=ccc.ccc.ccc.ccc

GW@=ddd.ddd.ddd.ddd, NMsk=fff.fff.fff.fff,

DNS1@=ggg.ggg.ggg.ggg,

DNS2@=hhh.hhh.hhh.hhh

Information only.

ENET[eee] IP-Cfg:HstName=x,

IP@=ccc.ccc.ccc.ccc, GW@=ddd.ddd.ddd.ddd,

NetMsk=fff.fff.fff.fff

Information only.

206 ThinkServer TD100 and TD100x: Hardware Maintenance Manual

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 253 254

Kommentare zu diesen Handbüchern

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 224

Kommentare zu diesen Handbüchern