Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 195)

Memory problems

v Follow the suggested actions in the order in which they are listed in the Action column until the problem

is solved.

v See Chapter 3, “Parts listing, TD100 Types 6398, 6399, 6419, 6429, 4203, and 4206,” on page 25 to

determine which components are customer replaceable units (CRU) and which components are field

replaceable units (FRU).

v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a

trained service technician.

Symptom Action

The amount of system memory

that is displayed is less than the

amount of installed physical

memory.

1. Make sure that:

v No error LEDs are lit on the control-panel assembly or on the system board.

v Memory mirroring does not account for the discrepancy.

v The memory modules are seated correctly.

v You have installed the correct type of memory.

v All DIMMs are enabled. The server might have automatically disabled a

DIMM when it detected a problem.

2. Check the POST error log for error message 289:

v If a DIMM was disabled by a system-management interrupt (SMI), replace

the DIMM.

3. Run memory diagnostics (see “Running the diagnostic programs” on page 189).

4. Make sure that there is no memory mismatch when the server is over the

minimum memory configuration (one 512 MB DIMM) and that you have

installed the correct number of DIMMs (see the User’s Guide on the IBM

System x3400 Documentation CD for information about installing memory

modules).

5. Reseat the DIMMs.

6. Replace the following components one at a time, in the order shown, restarting

the server each time:

a. DIMMs

b. (Trained service technician only) System board

Multiple rows of DIMMs in a

branch are identified as failing.

1. Reseat the DIMMs; then, restart the server.

2. Remove the lowest-numbered DIMM pair of those that are identified and

replace it with an identical pair of known good DIMMs; then, restart the server.

Repeat as necessary. If the failure continues after all identified pairs are

replaced, go to step 4

3. Return the removed DIMMs, one pair at a time, to their original connectors,

restarting the server after each pair, until a pair fails. Replace the failed DIMM

and restart the server. Repeat this step until you have tested all removed

DIMMs.

4. (Trained service technician only) Replace the system board.

Chapter 5. Diagnostics 177

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 253 254

Kommentare zu diesen Handbüchern

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 195

Kommentare zu diesen Handbüchern

Související produkty a manuály pro TV příslušenství Maxim-integrated MAX12527