Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 157)

Installing a microprocessor and heat sink

Important: Some models support dual-core processors and quad-core processors.

Do not mix dual-core and quad-core processors in the same server. Install all

dual-core processors or all quad-core processors in the server.

To install the microprocessor and heat sink, complete the following steps.

1 Heatsink 2 3 Microprocessor 2 VRM

2 Microprocessor 2 4 Microprocessor release lever

1. Touch the static-protective package that contains the microprocessor to any

unpainted metal surface on the server. Then, remove the microprocessor from

the package.

2. Remove the protective cover, tape, or label from the surface of the

microprocessor socket, if any is present.

3. Rotate the release lever on the microprocessor socket to the fully open

position.

Attention: Make sure that the release lever on the microprocessor socket is

in the fully open position before you insert the microprocessor in the socket.

Failure to do so might result in permanent damage to the microprocessor,

microprocessor socket, and system board.

Microprocessor

release lever

(fully open)

Microprocessor

bracket frame

Chapter 4. Removing and replacing server components 139

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 253 254

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 157