Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 154)

5. Lift up the power-supply cage handle and pull the power-supply cage assembly

all the way up until the retainer latch locks the cage in place on the chassis.

6. Disconnect the power supply docking cable assembly 1 from the system

board.

7. Using a phillips screwdriver, remove the three screws 2 that secure the

docking cable to the chassis; then, remove it from the chassis.

8. If you are instructed to return the power supply, follow all packaging instructions,

and use any packaging materials for shipping that are supplied to you.

Installing the hot-swap power supply docking cable assembly

To install a new hot-swap power supply docking cable assembly, complete the

following steps:

1. Position the hot-swap power supply docking cable assembly from the inside the

server and insert it in the power supply docking cable slot on the rear of the

chassis (aligning the holes with the screw holes on the chassis).

2. Secure the hot-swap power supply docking cable assembly to the chassis with

the three screws that you removed earlier.

3. Connect the hot-swap power supply docking cable to the system board.

4. Rotate the power supply cage back into the server.

5. Install the power supplies back into the power supply cage.

6. Install the side cover (see “Installing the side cover” on page 79).

7. Lock the side cover.

8. Reconnect the external cables and power cords; then, turn on the attached

devices and turn on the server.

136 ThinkServer TD100 and TD100x: Hardware Maintenance Manual

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 253 254

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 154