Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 135)

the system board. The ServeRAID-8k adapter 1 is not cabled to the system

board, and no rerouting of the SAS or SATA cable is required.

To remove the ServeRAID-8k adapter, complete the following.

1. Read the safety information that begins on page vii and “Handling

static-sensitive devices” on page 75.

2. Turn off the server and peripheral devices, and disconnect the power cords and

all external cables. Remove the left-side cover.

Attention: To avoid breaking the retaining clips or damaging the

ServeRAID-8k adapter connector, open and close the clips gently.

3. Unplug the battery pack cable from the adapter.

4. Open the retaining clips on each end of the ServeRAID-8k adapter connector

and remove the adapter from the server.

5. Remove the screws that secure the battery pack to the chassis; then, remove

the battery pack from the server. Be sure not to drop the screws into the server

chassis. If you are not going to replace the ServeRAID-8k adapter, reinstall the

battery pack mounting screws into the holes in the chassis, otherwise set them

aside for future use.

Installing the RAID-8k adapter

The optional ServeRAID-8k adapter can be installed only in its dedicated connector

on the system board. See the following illustration for the location of the connector

on the system board. The ServeRAID-8k adapter is not cabled to the system board,

and no rerouting of the SAS or SATA cable is required. However, if you install this

optional ServeRAID-8k adapter in simple-swap SATA models, see the following

instructions for cabling information.

To install the ServeRAID-8k adapter, complete the following steps.

Note: If you install this ServeRAID-8k adapter in simple-swap SATA models, be

sure to follow the instructions in this section for cabling.

1. Open the retaining clips on each end of the ServeRAID-8k adapter connector.

2. Touch the static-protective package that contains the ServeRAID-8k adapter to

any unpainted metal surface on the server. Then, remove the ServeRAID-8k

adapter and battery pack from the package.

3. Connect the battery pack cable to the ServeRAID-8k adapter.

4. Turn the ServeRAID-8k adapter 1 so that the ServeRAID-8k adapter keys

align correctly with the connector2.

Attention: Incomplete insertion might cause damage to the system board or

the ServeRAID-8k adapter.

Chapter 4. Removing and replacing server components 117

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 253 254

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 135