Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 134)

3. Carefully open the retaining clip on each end of the ServeRAID 8k-l adapter

connector and remove the adapter from the server.

4. If you are instructed to return the adapter, follow all packaging instructions, and

use any packaging materials for shipping that are supplied to you.

Installing the RAID 8k-l adapter

The IBM ServeRAID 8k-l adapter must be installed in its dedicated connector on the

system board. See the following illustration for the location of the connector on the

system board. The ServeRAID 8k-l adapter is not cabled to the system board and

no rerouting of the SCSI cable is required.

To install the ServeRAID 8k-l adapter, complete the following steps:

1. Read the safety information beginning on page “Safety” on page vii, and

“Installation guidelines” on page 73.

2. Turn off the server and peripheral devices, and disconnect the power cords

and all external cables. Remove the side cover (see “Removing the side cover”

on page 78.

Attention: To avoid breaking the retaining clips or damaging the

ServeRAID-8k-l adapter connector, open and close the clips gently.

3. Open the retaining clip on each end of the ServeRAID 8k-l adapter connector

1.

4. Touch the static-protective package containing the ServeRAID 8k-l adapter 2

to any unpainted metal surface on the server. Then, remove the ServeRAID

8k-l adapter from the package.

5. Turn the ServeRAID 8k-l adapter so that the ServeRAID 8k-l adapter keys

align correctly with the connector.

Attention: Incomplete insertion might cause damage to the system board or

the ServeRAID 8k-l adapter.

6. Press the ServeRAID 8k-l adapter firmly into the connector.

7. If you have other options to install or remove, do so now.

8. Replace the side cover (see “Installing the side cover” on page 79).

9. Lock the side cover.

10. Reconnect the external cables and power cords; then, turn on the attached

devices and turn on the server.

Removing the RAID-8k adapter

The ServeRAID-8k adapter can be installed only in its dedicated connector on the

system board. See the following illustration for the location of the connector 2 on

116 ThinkServer TD100 and TD100x: Hardware Maintenance Manual

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 253 254

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 134