Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 126)

Removing the front system fan cage assembly

Attention:

v Replace a failed fan within 48 hours.

v To ensure proper cooling and airflow, do not operate the server for more than 30

minutes with the side cover removed.

To remove the front system fan cage assembly, complete the following steps.

1. Read the safety information that begins on page vii and “Installation guidelines”

on page 73.

2. Turn off the server and all attached devices; then, disconnect all power cords

and external cables.

3. Unlock and remove the side cover (see “Removing the side cover” on page 78).

4. Rotate the power-supply cage assembly out of the chassis:

v Hot-swap models:

a. Remove the hot-swap power-supply. Press down on the orange release

lever and pull the power supply out of the bay, using the handle.

b. Lift up the power-supply cage handle and pull the power-supply cage

assembly all the way up until the retainer latch locks the cage in place on

the chassis.

v Non-hot-swap models, lift up the power-supply cage handle and pull the

power-supply cage assembly all the way up until the retainer latch locks the

cage in place on the chassis.

5. Press in on the fan cage assembly release buttons on both sides of the chassis

to release the front system fan cage assembly from the connector on the

chassis.

Fan cage assembly

release buttons

6. Pull the fan cage assembly up and out of the chassis.

7. If you are instructed to return the fan cage assembly, follow all packaging

instructions, and use any packaging materials for shipping that are supplied to

you.

108 ThinkServer TD100 and TD100x: Hardware Maintenance Manual

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 253 254

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 126