Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 119)

Attention: Static electricity that is released to internal server components when

the server is powered-on might cause the server to stop, which could result in the

loss of data. To avoid this potential problem, always use an electrostatic-discharge

wrist strap or other grounding system when working inside the server with the

power on.

To install a DIMM, complete the following steps:

1. Read the safety information that begins on page vii and “Safety statements” on

page x.

2. Turn off the server and peripheral devices, and disconnect the power cords

and all external cables.

3. Remove the side cover (see “Removing the side cover” on page 78).

4. Rotate the power-supply cage assembly out of the chassis:

v Hot-swap models:

a. Remove the hot-swap power-supply. Press down on the orange release

lever and pull the power supply out of the bay, using the handle.

b. Lift up the power-supply cage handle and pull the power-supply cage

assembly all the way up until the retainer latch locks the cage in place

on the chassis.

v Non-hot-swap models, lift up the power-supply cage handle and pull the

power-supply cage assembly all the way up until the retainer latch locks the

cage in place on the chassis.

5. Locate the DIMM connectors on the system board. Determine the connector in

which you will install the DIMMs. Install the DIMMs in the sequence indicated

in Table 15 on page 99 and Table 16 on page 100

Note: DIMM connectors 3, 6, 9, and 12 are not functional in ThinkServer

TD100 models. Do not install DIMMs in these connectors.

Attention: To avoid breaking the retaining clips or damaging the DIMM

connectors, open and close the clips gently.

6. Open the retaining clips 2 and, if necessary, remove any existing DIMM 1.

7. Touch the static-protective package that contains the DIMM to any unpainted

metal surface on the server. Then, remove the new DIMM from the package.

8. Turn the DIMM so that the DIMM keys align correctly with the slot.

Chapter 4. Removing and replacing server components 101

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 253 254

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 119