Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 115)

Removing a memory module

To remove a dual inline memory module (DIMM), complete the following steps.

1. Read the safety information that begins on page vii and “Installation guidelines”

on page 73.

2. Turn off the server and all attached devices; then, disconnect all power cords

and external cables.

3. Unlock and remove the side cover (see “Removing the side cover” on page 78).

4. Rotate the power-supply cage assembly out of the chassis:

v Hot-swap models:

a. Remove the hot-swap power-supply. Press down on the orange release

lever and pull the power supply out of the bay, using the handle.

b. Lift up the power-supply cage handle and pull the power-supply cage

assembly all the way up until the retainer latch locks the cage in place on

the chassis.

v Non-hot-swap models, lift up the power-supply cage handle and pull the

power-supply cage assembly all the way up until the retainer latch locks the

cage in place on the chassis.

5. Disconnect any cables that impede access to the DIMMs.

6. Locate the DIMM connector that contains the DIMM that is to be replaced (see

“System-board option connectors” on page 12 for DIMM slot locations).

Attention: To avoid breaking the DIMM retaining clips or damaging the DIMM

connectors, open and close the clips gently.

7. Carefully open the retaining clips 1 on each end of the DIMM connector and

remove the DIMM2.

8. If you are instructed to return the DIMM, follow all packaging instructions, and

use any packaging materials for shipping that are supplied to you.

Chapter 4. Removing and replacing server components 97

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 253 254

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 115