Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 107)

10. If you have a hot-swap model, reinstall the hot-swap power supplies (see

“Installing a hot-swap power supply” on page 96).

11. Install the side cover (see “Installing the side cover” on page 79).

12. Lock the side cover.

13. Reconnect the external cables and power cords; then, turn on the attached

devices and turn on the server.

Removing a hot-swap hard disk drive

Attention: To maintain proper system cooling, do not operate the server for more

than 10 minutes without either a drive or a filler panel installed in each drive bay.

To remove a hot-swap SAS or hot-swap SATA hard disk drive, complete the

following steps.

1. Read the safety information that begins on page vii and “Installation guidelines”

on page 73.

Note: You do not have to turn off the server to remove hot-swap drives from

the hot-swap drive bays.

2. Unlock the side cover.

3. Remove the bezel (see “Removing the bezel” on page 76).

4. Rotate the drive tray handle of the drive assembly to the open position.

1 Hard disk drive

2 Drive tray

3 Drive tray handle (in open position)

5. Grasp the handle of the drive assembly and pull the assembly out of the bay.

6. If you are instructed to return the drive assembly, follow all packaging

instructions, and use any packaging materials for shipping that are supplied to

you.

Chapter 4. Removing and replacing server components 89

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 253 254

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 107