Lenovo TD100 Bedienungsanleitung PDF herunterladen (Seite 10)

Guidelines for trained service technicians

This section contains information for trained service technicians.

Inspecting for unsafe conditions

Use the information in this section to help you identify potential unsafe conditions in

an IBM

product that you are working on. Each Lenovo product, as it was designed

and manufactured, has required safety items to protect users and service

technicians from injury. The information in this section addresses only those items.

Use good judgment to identify potential unsafe conditions that might be caused by

non-Lenovo alterations or attachment of non-Lenovo features or options that are not

addressed in this section. If you identify an unsafe condition, you must determine

how serious the hazard is and whether you must correct the problem before you

work on the product.

Consider the following conditions and the safety hazards that they present:

v Electrical hazards, especially primary power. Primary voltage on the frame can

cause serious or fatal electrical shock.

v Explosive hazards, such as a damaged CRT face or a bulging or leaking

capacitor.

v Mechanical hazards, such as loose or missing hardware.

To inspect the product for potential unsafe conditions, complete the following steps:

1. Make sure that the power is off and the power cord is disconnected.

2. Make sure that the exterior cover is not damaged, loose, or broken, and

observe any sharp edges.

3. Check the power cord:

v Make sure that the third-wire ground connector is in good condition. Use a

meter to measure third-wire ground continuity for 0.1 ohm or less between

the external ground pin and the frame ground.

v Make sure that the power cord is the correct type, as specified in “Power

cords” on page 61.

v Make sure that the insulation is not frayed or worn.

4. Remove the cover.

5. Check for any obvious non-Lenovo alterations. Use good judgment as to the

safety of any non-Lenovo alterations.

6. Check inside the server for any obvious unsafe conditions, such as metal filings,

contamination, water or other liquid, or signs of fire or smoke damage.

7. Check for worn, frayed, or pinched cables.

8. Make sure that the power-supply cover fasteners (screws or rivets) have not

been removed or tampered with.

viii ThinkServer TD100 and TD100x: Hardware Maintenance Manual

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 253 254

Keine Kommentare

Lenovo TD100 Bedienungsanleitung Seite 10