Lenovo AD80582QH056003 Datenblatt Seite 110

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 136
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 109
Features
110 Intel® Xeon® Processor 7400 Series Datasheet
Enhanced Intel SpeedStep Technology creates processor performance states (P-states)
or voltage/frequency operating points. P-states are lower power capability states within
the Normal state as shown in Figure 7-1. Enhanced Intel SpeedStep Technology
enables real-time dynamic switching between frequency and voltage points. It alters
the performance of the processor by changing the bus to core frequency ratio and
voltage. This allows the processor to run at different core frequencies and voltages to
best serve the performance and power requirements of the processor and system. The
Intel® Xeon® Processor 7400 Series have hardware logic that coordinates the
requested voltage (VID) between the processor cores. The highest voltage requested
from the four processor cores is selected for that processor package. Note that the
front side bus is not altered; only the internal core frequency is changed. In order to
run at reduced power consumption, the voltage is altered in step with the bus ratio.
The following are key features of Enhanced Intel SpeedStep Technology:
Multiple voltage/frequency operating points provide optimal performance at
reduced power consumption.
Voltage/frequency selection is software controlled by writing to processor MSR’s
(Model Specific Registers), thus eliminating chipset dependency.
If the target frequency is higher than the current frequency, V
CC
is incremented
in steps (+12.5 mV) by placing a new value on the VID signals and the
processor shifts to the new frequency. Note that the top frequency for the
processor can not be exceeded.
If the target frequency is lower than the current frequency, the processor shifts
to the new frequency and V
CC
is then decremented in steps (-12.5 mV) by
changing the target VID through the VID signals.
7.4 System Management Bus (SMBus) Interface
The Intel® Xeon® Processor 7400 Series package includes an SMBus interface which
allows access to a memory component with two sections (referred to as the Processor
Information ROM and the Scratch EEPROM). These devices and their features are
described below.
Note: The SMBus on-package thermal sensor has been removed and is no longer used. Refer
to Section 6.3 for details about the new digital thermometer and PECI interface.
The processor SMBus implementation uses the clock and data signals of the System
Management Bus (SMBus) Specification. It does not implement the SMBSUS# signal.
Layout and routing guidelines are available in the Caneland Platform Design Guide
document.
For platforms which do not implement any of the SMBus features found on the
processor, all of the SMBus connections, except SM_VCC, to the socket pins may be left
unconnected (SM_CLK, SM_DAT, SM_EP_A[2:0], SM_WP).
Seitenansicht 109
1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 135 136

Kommentare zu diesen Handbüchern

Keine Kommentare