Lenovo Computer Monitor 7098 Bedienungsanleitung PDF herunterladen (Seite 117)

100

101

Completing the FRU replacement

After replacing FRUs, you need to install any removed parts, replace the cover, and

reconnect any cables, including telephone lines and power cords. Also, depending

on the FRU that is replaced, you might need to confirm the updated information in

the Setup Utility program.

Note: When the power cord is first plugged in, the computer might appear to turn

on for a few seconds and then turn off. This is a normal sequence to enable

the computer to initialize.

1. Ensure that all components have been reassembled correctly and that no tools

or loose screws are left inside your computer.

2. Reposition any cables that might impede the replacement of the computer

cover.

Important

Correctly route all power supply cables to avoid interference with the

drive bay assembly. Keep cables clear of the hinges and sides of the

computer chassis.

3. Position the computer cover on the chassis so that the rail guides on the sides

of the cover engage the rails and push the cover to the closed position until it

snaps into position.

4. If the cover is secured with thumbscrews, install them.

5. Reconnect the external cables and power cords to the computer. See “Rear

connectors” on page 86.

6. If you have replaced the system board, you must update (flash) the BIOS. See

“Updating (flashing) BIOS from a CD-ROM or diskette” on page 786.

7. Some FRU replacements require the configuration to be updated. See Chapter 6,

“Using the Setup Utility,” on page 51.

Chapter 8. Replacing FRUs- Rocky computers 111

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 797 798

Kommentare zu diesen Handbüchern

Keine Kommentare

Lenovo Computer Monitor 7098 Bedienungsanleitung Seite 117

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motherboards Lenovo Computer Monitor 7098