Lenovo THINKCENTRE 6396 Bedienungsanleitung PDF herunterladen (Seite 96)

Replacing a hard disk drive

This section provides instructions on how to replace the hard disk drive.

Important

When a new hard disk drive is installed, a set of Product Recovery discs might

be required. The set of Product Recovery discs enable the contents of the hard

disk to be restored to the same state as when the computer was originally

shipped from the factory. For more information on recovering

factory-installed software, refer to ″Recovering Software″ in the User Guide.

To replace the hard disk drive:

1. Open the computer cover. See “Opening the cover” on page 84.

2. Disconnect the power cable from the optical drive.

3. Place your finger on the tab located on the front of the hard disk drive and

push upward. Then press inward on the side tabs and pivot the hard disk

drive upward to remove.

4. Remove the failing hard disk drive from the chassis.

5. Disconnect the signal and power cables from the hard disk drive.

6. Remove the hard disk drive from the plastic bracket by flexing the sides of the

bracket enough to slide it free of the hard disk drive.

90 Hardware Maintenance Manual

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 163 164

Keine Kommentare

Lenovo THINKCENTRE 6396 Bedienungsanleitung Seite 96