ThinkCentreHardware Installation and Replacement GuideMachine Types 6137, 6234, 6258, 6303, 7174, 7220, 7346, 7354, 7357,7360, 7483, 7627, 7630, 7638,
2 ThinkCentre Hardware Installation and Replacement Guide
Chapter 2. Overview This guide provides information about installing and or replacing Customer Replaceable Units (CRUs). However, this
Handling static-sensitive devices Do not open the static-protective package containing the new part until the defective part has been
Locations This section provides illustrations to help locate the various connectors, controls, and components of the computer. Locating
Locating connectors on the rear of your computer Figure 2 shows the location of connectors on the rear of your computer. Some conn
Connector Description USB connector Used to attach a device that requires a Universal Serial Bus (USB) connector, such as a USB key
Locating components To open the computer cover, see “Opening the cover” on page 12. Figure 3 shows the location of the various com
Identifying parts on the system board Figure 4 shows the location of parts on the system board. 1 PCI adapter card slot 11
10 ThinkCentre Hardware Installation and Replacement Guide
Chapter 3. Installing options and replacing hardware This chapter provides an introduction to the features and options that are avai
Installing internal options Important Read “Handling static-sensitive devices” on page 4 before opening the computer cover.Opening the
Accessing system board components and drives To access system board components and the drives: 1. Open the computer cover. See “Op
5. Open the retaining clips. 6. Position the memory module over the memory slot. Make sure that the notch 1 on the memory
Installing an adapter card This section provides information and instructions for installing adapter cards. Your computer has one PCI
Installing internal drives This section provides information and instructions for installing internal drives. Internal drives are device
Drive specifications Your computer comes with the following factory-installed drives: v A 3.5-inch hard disk drive in bay 1 v An
Installing a drive in bay 2 To install an optical drive or an additional hard disk drive in bay 2: 1. Open the computer cover.
3. Locate one of the extra five-wire power cables and connect it to the drive. What to do next: v To work with another op
Replacing the battery Your computer has a special type of memory that maintains the date, time, and settings for built-in features,
Replacing the power supply Attention Do not open your computer or attempt any repair before reading the “Important safety information
ThinkCentre Hard ware Installation and Replacement Gui de
5. Disconnect the power supply cables from the power connectors 1 and 2 and from all drives.Note: You might need to remove
Note: Use only the screws provided by Lenovo. 9. Install and tighten the four screws at the rear of the chassis to secure the
3. Disconnect the heat sink and fan assembly cable from the system board. See “Identifying parts on the system board” on page 9
Replacing a hard disk drive Attention Do not open your computer or attempt any repair before reading the “Important safety informati
6. Remove the failing hard disk drive from the bracket by flexing the bracket. 7. To install the new drive into the bracket,
2. Pivot the drive bay assembly upward to gain access to the optical drive. 3. Disconnect the signal and power cables from
6. Install the new optical drive into the bay until it snaps into position. 7. Connect the signal and power cables to the r
2. Pivot the drive bay assembly upward to gain access to the system board. See “Accessing system board components and drives” on
5. Position the replacement memory module over the memory slot. Make sure the notch 1 on the memory module aligns correctly wi
2. Rotate the adapter card retainer 1 to the open position to remove the failing adapter card. 3. Remove the failing adapter
Note Before using this information and the product it supports, be sure to read and understand the ThinkCentre Safety and Warranty
5. Remove the screw that secures the card reader to the chassis. 6. Remove the card reader from the chassis. 7. Install th
Replacing the keyboard Attention Do not open your computer or attempt any repair before reading the “Important safety information” in
Note: Your mouse might be connected to a standard mouse connector 1 or a USB connector 2. Depending on where your mouse is c
Chapter 4. Completing the parts replacement After completing all parts replacements, you need to close the cover and reconnect cables
Note: In most areas of the world, Lenovo requires the return of the defective CRU. Information about this will come with the CRU
Chapter 5. Security features To help prevent hardware theft and unauthorized access to your computer, several security lock options a
Password protection To deter unauthorized use of your computer, you can use the Setup Utility program to set a password. When you
Appendix. Notices Lenovo may not offer the products, services, or features discussed in this document in all countries. Consult your
vary significantly. Some measurements may have been made on development-level systems and there is no guarantee that these measuremen
Index Aadapterinstalling 15 adapter card 15 adapter card, replacing 30 audio line-in connector 7 audio line-out connector 7 Bbattery, rep
Contents Figures . . . . . . . . . . . . . . .v Chapter 1. Important safety information 1 Chapter 2. Overview . . . . .
resources, information 3 Ssafety information 1 securitycable lock 37 features, installing 37 serial port 7 static-sensitive devices, handl
Part Number: 46R4690 Printed in USA (1P) P/N: 46R4690
iv ThinkCentre Hardware Installation and Replacement Guide
Figures 1. Controls and connectors . . . . . . . . .5 2. Connector locations . . . . . . . . . .6 3. Component loc
vi ThinkCentre Hardware Installation and Replacement Guide
Chapter 1. Important safety information CAUTION: Before using this manual, it is important that you read and understand all the rela
Kommentare zu diesen Handbüchern