Lenovo 5354 Bedienungsanleitung PDF herunterladen (Seite 29)

Note: The new system fan assembly comes together with four new rubber

mounts: two short rubber mounts and two long rubber mounts.

6. Install the two new long rubber mounts by pushing them through the holes on

the rear of the chassis. If necessary, pull the rubber mounts through the holes

from the inside of the chassis to make sure that the rubber mounts are installed

in place.

7. To install the new system fan assembly into the chassis, align the holes on the

new system fan assembly with the long rubber mounts in the chassis. Then,

push or pull the rubber mounts through the holes until the new system fan

assembly is secured in place.

8. Connect the cable of the new system fan assembly to the system fan connector

on the system board.

9. Reinstall the hard disk drive if you have removed it.

What to do next:

v To work with another piece of hardware, go to the appropriate section.

v To complete the replacement, go to “Completing the parts replacement” on

page 24.

Figure 18. Installing the short rubber mounts

Figure 19. Installing the system fan assembly

Chapter 2. Installing or replacing hardware 21

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 67 68

Keine Kommentare

Lenovo 5354 Bedienungsanleitung Seite 29