Lenovo THINKSERVER TS100 6434 Bedienungsanleitung PDF herunterladen (Seite 62)

3. Select Start Options and press Enter. Make sure that Planar Ethernet

PXE/DHCP is set to Enabled. Select Startup Sequence Options and press

Enter; then, set the PCI LAN: Planar device as the first startup device.

4. Press Esc twice to exit.

5. Select Save Settings in the Configuration/Setup Utility main menu and press

Enter to save your changes.

Configuring the Broadcom NetXtreme Gigabit Ethernet controller

The Ethernet controller is integrated on the system board. It provides an interface

for connecting to a 10 Mbps, 100 Mbps, or 1 Gbps network and provides full

duplex (FDX) capability, which enables simultaneous transmission and reception of

data on the network. If the Ethernet port in the server supports auto-negotiation,

the controller detects the data-transfer rate (10BASE-T, 100BASE-TX, or

1000BASE-T) and duplex mode (full-duplex or half-duplex) of the network and

automatically operates at that rate and mode.

You do not have to set any jumpers or configure the controller. However, you must

install a device driver to enable the operating system to address the controller. For

device drivers and information about configuring the Ethernet controller, see the

Broadcom NetXtreme Gigabit Ethernet Software CD that comes with the server. To find

updated information about configuring the controller, complete the following steps.

Note:

Changes are made periodically to the Lenovo Web site. The actual procedure

might vary slightly from what is described in this document.

1. Go to: http://www.lenovo.com/support.

2. Enter your product number (machine type and model number) or select

Servers and Storage from the Select your product list.

3. Select Servers and Storage from the Brand list.

4. From Family list, select ThinkServer TS100, and click Continue.

5. Click User's guides and manuals for documentation.

LSI Configuration Utility program

Use the LSI Configuration Utility program to configure and manage redundant

array of independent disks (RAID) arrays. Be sure to use these programs as

described in this document.

v Use the LSI Configuration Utility program to:

– Perform a low-level format on a SAS hard disk drive

– Create an array of SAS hard disk drives with or without a hot-spare drive

– Set SAS protocol parameters on SAS hard disk drives

The

integrated SAS/SATA controller with RAID capabilities supports RAID arrays.

You can use the LSI Configuration Utility program to configure RAID 1 (IM),

RAID 1E (IME), and RAID 0 (IS) for a single pair of attached devices. If you install

a different type of RAID adapter, follow the instructions in the documentation that

comes with the adapter to view or change SAS settings for attached devices.

In addition, you can download an LSI command-line configuration program from

http://www.lenovo.com/support.

Consider the following information when you are using the LSI Configuration

Utility program to configure and manage arrays:

48 ThinkServer TS100 Types 6431, 6432, 6433, 6434: Installation Guide

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 109 110

Kommentare zu diesen Handbüchern

Keine Kommentare

Lenovo THINKSERVER TS100 6434 Bedienungsanleitung Seite 62

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computers Lenovo THINKSERVER TS100 6434