Lenovo THINKSERVER TS100 6434 Bedienungsanleitung PDF herunterladen (Seite 36)

v You must install either all SAS hot-swap hard disk drives or all SATA hot-swap

hard disk drives in the server. Do not use both SAS and SATA drives in the

same server.

v Install drives in the following sequence:

– For server models that support four hard disk drives, install the drives

starting from the top bay to the bottom bay (bay 4, 5, 6, and then 7).

– For server models that support eight hard disk drives, install the drives

starting from left to right (bay 4, 5, 6, 7, 8, 9, 10, and then 11).

Inspect the drive tray for signs of damage.

v Make sure that the drive is correctly installed in the tray.

v You do not have to turn off the server to install hot-swap drives in the hot-swap

drive bays.

The

server hot-swap bays are connected to a SAS/SATA hard disk drive backplane.

This backplane, also known as the hot-swap-drive backplane, is the printed circuit

board behind these bays.

Attention: Static electricity that is released to internal server components when

the server is powered-on might cause the server to stop, which might result in the

loss of data. To avoid this potential problem, always use an electrostatic-discharge

wrist strap or other grounding system when you work inside the server with the

power on.

To install a hot-swap SAS or hot-swap SATA hard disk drive, complete the

following steps:

1. Read the safety information that begins on page v and “Installation guidelines”

on page 7.

2. Unlock the side cover.

3. Remove the lower bezel (see “Removing the two-piece bezel” on page 11).

4. Touch the static-protective package that contains the drive to any unpainted

metal surface on the server; then, remove the drive from the package and place

it on a static-protective surface.

5. Install the hard disk drive in the hot-swap bay:

a. Make sure that the drive tray handle is open.

b. Align the drive assembly with the guide rails in the bay.

22 ThinkServer TS100 Types 6431, 6432, 6433, 6434: Installation Guide

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 109 110

Keine Kommentare

Lenovo THINKSERVER TS100 6434 Bedienungsanleitung Seite 36