Lenovo 3000 J Series Bedienungsanleitung PDF herunterladen (Seite 68)

Changing the startup device sequence

To view or permanently change the configured startup device sequence, do the

following:

1. Start the Setup Utility program (see “Starting the Setup Utility program” on

page 47).

2. Select Startup.

3. Select Startup Sequence. See the information displayed on the right side of the

screen.

4. Select the devices for the Primary Startup Sequence, the Automatic Startup

Sequence, and the Error Startup Sequence.

5. Select Exit from the Setup Utility menu and then Save Settings or Save and

exit the Setup Utility.

If you have changed these settings and want to return to the default settings, select

Load Default Settings on the Exit menu.

Advanced settings

On some computer models the Advanced settings menu includes a setting to

Enable/Disable HyperThreading. This feature works only with

HyperThreading-aware operating systems such as Microsoft Windows XP. The

default setting for HyperThreading is Enabled. However, if you select Set Defaults

and are using an operating system other than Windows XP, your computer

performance might be degraded. Therefore, you should always set

HyperThreading to Disabled unless you are sure your operating system supports

HyperThreading.

Exiting from the Setup Utility program

When you finish viewing or changing settings, press Esc to return to the Setup

Utility program menu (you might have to press Esc several times). If you want to

save the new settings, select Save Settings or Save and exit the Setup Utility.

Otherwise, your changes will not be saved.

50 User Guide

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 95 96

Keine Kommentare

Lenovo 3000 J Series Bedienungsanleitung Seite 68