Lenovo ThinkServer TD200x Bedienungsanleitung PDF herunterladen (Seite 79)

To install the replacement battery, do the following:

1. Follow any special handling and installation instructions that come with the

replacement battery.

2. Insert the replacement battery 1:

a. Hold the battery in a vertical orientation so that the smaller side is facing the

socket.

b. Place the battery into its socket, and press the battery towards the socket

until it clicks into place. Make sure that the battery clip holds the battery

securely.

3. Install and lock the left-side cover (see “Installing the side cover” on page 99).

4. Reconnect the external cables and power cords; then, turn on the attached

devices and turn on the server.

Note: You must wait approximately 2 1/2 minutes after you connect the server

power cord to an electrical outlet before the power-control button becomes

active.

5. Start the Setup Utility and reset the configuration:

v Set the system date and time.

v Set the power-on password.

v Reconfigure the server.

See “Starting the Setup Utility” on page 104 for details.

Removing a hot-swap power supply

If you remove a hot-swap power supply, observe the following precautions.

Statement 8:

CAUTION:

Never remove the cover on a power supply or any part that has the following

label attached.

Hazardous voltage, current, and energy levels are present inside any

component that has this label attached. There are no serviceable parts inside

these components. If you suspect a problem with one of these parts, contact

a service technician.

Note: If only one hot-swap power supply is installed in the server, you must turn off

the server before removing the power supply.

Chapter 5. Installing optional devices and replacing customer replaceable units 63

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 213 214

Keine Kommentare

Lenovo ThinkServer TD200x Bedienungsanleitung Seite 79