Lenovo ThinkServer TD200x Bedienungsanleitung PDF herunterladen (Seite 155)

2. Check for loose cables in the power subsystem. Also check for short circuits, for

example, if a loose screw is causing a short circuit on a circuit board.

3. Remove the adapters and disconnect the cables and power cords to all internal

and external devices until the server is at the minimum configuration that is

required for the server to start (see “Solving undetermined problems” on page

140 for the minimum configuration).

4. Reconnect all ac power cords and turn on the server. If the server starts

successfully, replace the adapters and devices one at a time until the problem is

isolated.

If the server does not start from the minimum configuration, replace the components

in the minimum configuration one at a time until the problem is isolated.

Solving Ethernet controller problems

The method that you use to test the Ethernet controller depends on which operating

system you are using. See the operating-system documentation for information

about Ethernet controllers, and see the Ethernet controller device-driver readme file.

Try the following procedures:

v Make sure that the correct device drivers, which come with the server, are

installed and that they are at the latest level.

v Make sure that the Ethernet cable is installed correctly.

– The cable must be securely attached at all connections. If the cable is

attached but the problem remains, try a different cable.

– If the Ethernet controller is set to operate at 100 Mbps, you must use

Category 5 cabling.

– If you directly connect two servers (without a hub), or if you are not using a

hub with X ports, use a crossover cable. To determine whether a hub has an

X port, check the port label. If the label contains an X, the hub has an X port.

v Determine whether the hub supports auto-negotiation. If it does not, try

configuring the integrated Ethernet controller manually to match the speed and

duplex mode of the hub.

v Check the Ethernet controller LEDs on the rear panel of the server. These LEDs

indicate whether there is a problem with the connector, cable, or hub.

– The Ethernet link status LED is lit when the Ethernet controller receives a link

pulse from the hub. If the LED is off, there might be a defective connector or

cable or a problem with the hub.

– The Ethernet transmit/receive activity LED is lit when the Ethernet controller

sends or receives data over the Ethernet network. If the Ethernet

transmit/receive activity light is off, make sure that the hub and network are

operating and that the correct device drivers are installed.

v Check the LAN activity LEDs on the rear of the server. The LAN activity LED is lit

when data is active on the Ethernet network. If the LAN activity LED is off, make

sure that the hub and network are operating and that the correct device drivers

are installed.

v Check for operating-system-specific causes of the problem.

v Make sure that the device drivers on the client and server are using the same

protocol.

If the Ethernet controller still cannot connect to the network but the hardware

appears to be working, the network administrator must investigate other possible

causes of the error.

Chapter 7. Troubleshooting 139

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 213 214

Kommentare zu diesen Handbüchern

Keine Kommentare

Lenovo ThinkServer TD200x Bedienungsanleitung Seite 155

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerhardware Lenovo ThinkServer TD200x