Lenovo THINK CENTRE 9159 Bedienungsanleitung PDF herunterladen (Seite 39)

Capitolo 4. Completing the parts replacement

After working with parts, you need to replace the computer cover and reconnect

any cables, including telephone lines and power cords. Also, depending on the

part that was replaced, you might need to confirm the updated information in the

Setup Utility program.

To replace the computer cover and connect cables to your computer:

1. Ensure that all components have been reassembled correctly and that no tools

or loose screws are left inside your computer.

2. Reposition any cables that might impede the replacement of the computer

cover.

Important

Correctly route all power supply cables to avoid interference with the

drive bay assembly. Keep cables clear of the hinges and sides of the

computer chassis.

3. Align the drive bay assembly with the two slots and rails on the sides of the

chassis, reconnect the drive cables on the system board, and then slide the

drive bay assembly towards the rear of the chassis until it snaps into position.

4. Reinstall the front bezel if it was removed.

5. Position the computer cover on the chassis so that the rail guides on the sides

of the cover engage the rails and push the cover to the closed position until it

snaps into position. If your computer has screws to secure the computer cover,

install the screws.

6. Install any locking devices such as a padlock as necessary.

7. Reconnect the external cables and power cords to the computer. See “Locating

connectors on the rear of your computer” a pagina 5.

8. To update the configuration, see “Using the Setup Utility” in the User Guide that

was included with your computer.

Figura 39. Sliding on the cover

Lenovo THINK CENTRE 9159 Bedienungsanleitung Seite 39