Lenovo THINK CENTRE 9159 Bedienungsanleitung PDF herunterladen (Seite 31)

7. Align the drive bay assembly with the two slots and rails on the sides of the

chassis, reconnect the drive cables on the system board, and then slide the

drive bay assembly towards the rear of the chassis until it snaps into position.

8. Reinstall the front bezel.

9. Go to Capitolo 4, “Completing the parts replacement”, a pagina 31.

Replacing an optical drive

Attention

Do not open your computer or attempt any repair before reading the “Important safety

information” in the Safety and Warranty Guide that was included with your computer for

the computer. To obtain copies of the Safety and Warranty Guide, go to

http://www.lenovo.com/support.

This section provides instructions on how to replace the optical drive.

1. Remove the computer cover. See “Removing the cover” a pagina 9.

2. Remove the bezel and drive bay assembly. See “Accessing system board

components and drives” a pagina 10.

3. Release the optical drive by pressing inward on the blue retainer at the side of

the drive.

4. Slide the optical drive being replaced out the front of the drive bay assembly.

5. Remove the retainer bracket from the failing drive and install it on the new

drive.

Figura 26. Installing the new diskette drive

Figura 27. Removing the optical drive

Capitolo 3. Installing options and replacing hardware 23

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Keine Kommentare

Lenovo THINK CENTRE 9159 Bedienungsanleitung Seite 31